PD Water Systems - Flux Boosting Systems
FBSPE 05G35P - Easy Pump Systems
The PRESFLO WELL SYSTEM starts and stops the water pump according to the user’s needs.
It replaces the traditional pressure system of a tank,
pressure switch and float switch, offering more advantages such as:
- Easy installations.
- Reduced dimensions.
- Constant flow.
- No maintenance required.
- No need to install pressure tanks.
- Pump protection against running dry with automatic reset.
The PRESFLO WELL SYSTEM monitors the water pressure and flow rate that runs through and protects the pump against dangerous working conditions like running dry. When a tap is opened, PRESFLO starts the pump and keeps it running, delivering constant flow. PRESFLO stops the pump when the demand is near zero.
PRESFLO WELL SYSTEM is made up of a water pump and an electronic pump controller which pulls water out of shallow wells, underground tanks, ponds or lakes to be used for:
- Residential boosting systems
FEATURES AND BENEFITS
PRESFLO’s body made of technopolymer with built-in check valve.
Pressure loss is extremely low, for this reason it is possible to use PRESFLO WELL SYSTEMS with capacity up to 50 gpm.
The special valve guarantees the pump continuous operation even with capacity as low as 0.2 gpm.
Spring/membrane water accumulator. A special membrane guarantees a high level of protection against overpressure. PRESFLO’s high capacity is essential to avoid frequent starts/stops of the pump in case of a leak in the pipeline.
Circuit board: Easy to replace, available in 115V and 230V.
PRESFLO WELL SYSTEMS come available with different pumps, for maximum working pressure up to 70 PSI’s and flow rates up to 50 gpm.
For clean liquids without abrasives, without suspended solids, non-explosive, non-aggressive for the pump materials.
For increasing network pressure (follow local specifications).
For the reduced dimensions, these pumps are very well suitable to be mounted in cooling and air-conditioning machines and equipments, circulation, boiler feed.
Liquid temperature up to 140 °F.
Ambient temperature up to 104 °F.
Total suction lift up to 23 ft.
2-pole induction motor, 60 Hz (n = 3450 rpm).
Three-phase 220/460 V.
Single-phase 115 V, 230 V, with thermal protector.
Capacitor inside the terminal box.
Insulation class F.
Protection IP 44.
Pump casing: Cast iron GJL 200 EN 1561
Casing cover motor side: Brass CW510L (lead free public LAW 111-380)
Impeller: Brass CW510L (lead free public LAW 111-380)
Shaft: Chrome steel AISI 430
Mechanical seal: Carbon - Ceramic - NBR
SPECIAL FEATURES ON REQUEST:
- Other voltages.
- Special mechanical seal.
- Higher or lower liquid or ambient temperatures.
Make click to enlarge the image or other views